IMPORTANT: Before entering programming mode, have in possession all of the transmitters you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory. The other transmitters will not be functional until you program the transmitters again.

1.Close and lock all doors with the driver’s side power lock/unlock switch.

2.Insert key into ignition and remove it from the ignition key cylinder at least six times
within 10seconds. YourHazard Lamps will flash if you have performed this step
successfully. NOTE: Withdraw key completely fromignition cylindereach time. If this
procedure is performed too fast, system will not enter programming mode.

3.Insert key into the ignition cylinder and turn to the ACC position.

4.Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should
flash.NOTE: Do not pressthe button more than one time in the above step. If the button
ispressed more than one time,theprogrammingprocedure will not be successful.

5.If there are any remaining transmitters (including the old ones), unlock then lock all doors
using thedriver’s sidepower lock/unlock switch and within 5 seconds, push ANY button
 on the next remote. Your HazardLamps shouldflash. Repeat this step for each
transmitter(including any existing transmitters).

6.Turn the keyto the OFF position,remove keys from the ignition, unlock doors usingthe
driver’s side power lock/unlock switch and open the driver side door.